Turn on the headlights to test the
new bulb.
Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Put the light assembly into the
bumper. Tighten the mounting
bolt.
Remove the socket by turning it
one-quarter turn counterclockwise.
Open the tailgate. Use a
screwdriver protected with a cloth
to pry open the two covers.
Remove the two screws and
remove the rear light assembly
from the rear pillar.
Determine which of the four bulbs
is burned out: brake/taillight, turn
signal/hazard lights, side marker
light, or back-up light.
Remove the burned out bulb. To
remove the brake/taillight, back-
up or side marker light bulb, pull
the bulb straight out of its socket.
To remove the turn signal/hazard
light bulb, push it in and turn it
counterclockwise until it unlocks.
1.
2.
3.
4.
8.
6.
7.
5.
Replacing Rear Bulbs
Lights
Maintenance
344
To Next Page
Loading...
Need help?
General
