In most areas, there is a variation
between magnetic north and true
north. Zone selection is required so
the compass can compensate for this
variation. To check and select the
zone set into the compass, do the
following.
Press and hold the CLOCK and
TRIP buttons until the display
changes (about 1 second).
Press the Zone (A/C) button. The
zone the compass is currently set
to is displayed.
Find the zone for your area on the
map.
If the zone is incorrect, press and
hold the MODE button to get the
number to count down, or the A/C
button to get the number to count
up. If the zone is correct, continue
to step 5.
Press the Set (FAN) button to set
the zone selection.
Press the CLOCK, TRIP or
RESET button to exit the zone
selection and return display to
normal.
1.
2.
3.
4.
5.
6.
Trip Computer
Comfort and Convenience Features
Compass Zone Selection
150
To Next Page
Loading...
Need help?
General
