CONTINUED
To remove slack, it may help to
putweightonthechildseat,or
push on the back of the seat while
pulling up on the belt.
Push and pull the child seat
forward and from side to side to
verify that it is firmly secured. If
the child seat is not secure,
unlatch the belt, allow it to retract
fully, then repeat these steps.
To deactivate the locking
mechanism and remove a child seat,
unlatch the buckle, unroute the seat
belt, and let the belt fully retract.
A child seat with a tether can be
installed in any seating position in
the second or third row.
Since a tether can provide additional
security to the lap/shoulder belt
installation, we recommend using a
tether whenever one is required or
available. (Tethers are required in
Canada.)
Confirm that the belt is locked,
then grab the shoulder part of the
belt near the buckle, and pull up to
remove any slack from the lap part
of the belt. Remember, if the lap
part of the belt is not tight, the
child seat will not be secure.
4. 5.
Installing a Child Seat
Driver and Passenger Safety
Installing a Child Seat with a
Tether
45
To Next Page
Loading...
Need help?
General
