Acura 2005 Acura TSX User Manual

Open the hood. To change a bulb
on the driver’s side, undo the
three fasteners and remove the air
intake cover.
Remove the electrical connector
from the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Unclip the end of the hold-down
wire from its slot. Pivot it out of
the way and remove the bulb.
Insert the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
Install the rubber weather seal
over the back of the headlight
assembly.Makesureitisright
side up; it is marked with an arrow.1. 2.
3.
6.
4.
5.
Lights
216
FASTENER
AIR INTAKE COVER
HOLD-DOWN WIRE
BULB
CONNECTOR
RUBBER WEATHER SEAL

Acura 2005 Acura TSX Specifications

General

Brand	Acura
Model	2005 Acura TSX
Category	Automobile
Language	English