Check the fluid level in the brake
fluid reservoir monthly. Replace it
according to the maintenance
schedule recommendations.
The fluid level should be between
theMINandMAXmarksontheside
of the reservoir. If the level is at or
below the MIN mark, your brake
system needs attention. Have the
brake system inspected for leaks or
worn brake pads.
If you are not sure how to add fluid,
contact your dealer.
The transmission should be drained
and refilled with new fluid according
to the time and distance recommen-
dations in the maintenance schedule.
Insert the dipstick all the way back
in the transmission.
To thoroughly flush the transmission,
the technician should drain and refill
it with Acura ATF-Z1 (Automatic
Transmission Fluid), then drive the
vehicle for a short distance. Do this
three times. Then drain and refill the
transmission a final time. Always use Acura Precision Crafted
Heavy Duty Brake Fluid DOT 3. If it
is not available, you should use only
DOT 3 or DOT 4 fluid, from a sealed
container, as a temporary
replacement.
Brake fluid marked DOT 5 is not
compatible with your vehicle’s
braking system and can cause
extensive damage.
Using any non-Acura brake fluid can
cause corrosion and decrease the life
of the system. Have the brake
system flushed and refilled with
Acura Heavy Duty Brake Fluid
DOT 3 as soon as possible.
6.
Brake Fluid
Automatic Transmission Fluid, Brake Fluid
Maintenance
243
MAX
MIN
To Next Page
Loading...
Need help?
General
