Open the tailgate. Use a
screwdriver protected with a cloth
to pry open the two covers.
Remove the two screws and
remove the rear light assembly
from the rear pillar.
Determine which of the four bulbs
is burned out: brake/taillight, turn
signal/hazard lights, side marker
light, or back-up light.
Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the burned-out bulb by
pulling it straight out of the socket.
Install the new bulb into the
socket.
Push the socket into the light
assembly, and turn it clockwise
until it locks.
Testthelightstomakesurethe
new bulb is working.
Install the rear light assembly in
the body. Tighten the two screws.
Snap the covers back into position.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Replacing Rear Bulbs
Lights
Maintenance
247
To Next Page
Loading...
