▼▲
Press and release the SET button
repeatedly. The mode switches
from hours, minutes, AM/PM,
year, month, then to day as shown
above.
Select the desired mode by
pressing the SET button, then
presseitherorbuttonto
change the setting.
After you set the day information,
pressing the SET button again will
cancel this setting mode and the
system shows the adjusted display.
The system will also automatically
return to the normal display about 10
seconds after you stop adjusting a
mode.
The navigation system receives
signals from the global positioning
system (GPS), and the displayed
time is updated automatically by the
GPS. Refer to the navigation system
manual for how to adjust the time.
You can see the clock and calendar
information on the upper display.
Press and hold the SET button
until the clock display begins to
blink.
To set the clock and the calendar:
1.
2.
3.
4.
On models with navigation system
On models without navigation system
Setting the Clock and Calendar
236
: Press SET
U.S. model is shown
０７／０７／０９ ０９：５３：４２ ３１ＳＴＸ６１０ ０２４１
To Next Page
Loading...
Need help?
General
