82 Navigation System
System Set-up
Set up Mode
The Set up function consists of two
main screens that allows you to change
and update information in the system.
To display the Set up screens, use the
voice control system and say “Set up” or
press the SET UP button. To change it
to another Set up screen, say or select
MORE in the upper right corner of the
screen.
On any of the Set up screens, you can
use the voice control system to select
any item on the screen.
NOTE:
• If some items appear to be grayed
out, and cannot be selected, it is
because you did not select OK on the
initial Disclaimer screen. See
System Start-up on page 17.
• For information on the available
voice commands, see Voice
Set up Screen (first)
From any screen, say “Set up screen” or
press the SET UP button, and the
following screen appears:
Brightness
The screen brightness has 11 settings.
To change the brightness, use the voice
control system and say “Brightness up”
or “Brightness down.” You can also
select Brightness and change the
setting by rotating the Interface Dial
knob.
Tip:
If you are having trouble viewing the
screen in bright lighting conditions, try
increasing the brightness.
Contrast
The screen contrast has 11 settings. To
adjust the contrast, use the voice control
system and say “Contrast up” or
“Contrast down.” You can also select
Contrast and change the setting by
rotating the Interface Dial knob.
Black Level
The screen black level has 11 settings.
To change the black level, use the voice
control system and say “Black level up”
or “Black level down.” You can also
select Black Level and change the
setting by rotating the Interface Dial
knob.
NOTE:
You can have separate daytime and
nighttime settings for Brightness,
Contrast, and Black Level. Adjust each
setting when the display is in either
daytime or nighttime mode. Use the
Display mode button (page 11
and 103) to select Daytime or Nighttime
mode.
Command Index on page 143.
To Next Page
Loading...
Need help?
General
