Navigation System 73
System Set-up
Display
There are two screen display modes:
Day and Night. The recommended
setting is Auto, which automatically
switches the screen between Day and
Night modes as you turn the headlights
on or off.
You can select Day or Night mode to
override the Auto mode. This is a
useful feature for driver’s that like to
use headlights during the day, and want
to temporarily override Night mode.
However, the screen in Day mode will
be extremely bright at night.
Day Mode Night Mode
Display
Mode
How setting affects
display mode:
To override setting
while driving:
But remember:
Off Turns off the
navigation display.
To “wake up” display,
press NAVI TALK
button, and select the
mode by voice.
Remember, your route
guidance stops when
the display is off.
Auto
(factory
default)
Automatically switches
between Day and
Night mode by sensing
if the headlights are on.
Override night
display - Adjust dash
brightness to full
bright. Override day
display - Turn on
headlights and ensure
the dash brightness is
not at full bright.
Remember to adjust the
dash brightness back to
normal to allow auto
switching by sensing
headlights.
Day Stays in Day mode. Push and hold the
joystick for 10 seconds
(switches to Night
mode).
There is no auto Night/
Day mode change with
the headlights on/off.
You control the setting.
Night Stays in Night mode. Push and hold the
joystick for 10 seconds
(switches to Day
mode).
There is no auto Night/
Day mode change with
the headlights on/off.
You control the setting.
To Next Page
Loading...
Need help?
General
