You can choose this customize item
from ‘‘WIPER SETUP’’ by pressing
the INFO (▲/▼) button repeatedly.
Press the SEL/RESET button to see
the selections.
Select the desired setting by
pressing the INFO (▲/▼) button,
then enter your selection by pressing
the SEL/RESET button.
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘WIPER ACTION’’ and repeat the
procedure again.
Multi-Information Display
114
08/06/06 16:58:07 09 ACURA MDX MMC North America Owner's M 50 31STX620 enu
To Next Page
Loading...
