1. MIST
2. OFF
3. INT － Intermittent
4. LO － Low speed
5. HI － High speed
6. Windshield washers
Push the right lever up or down to
select a position.
MIST － The wipers run at high
speed until you release the lever.
OFF － The wipers are not activated.
INT － The length of the wipe
interval is varied automatically
according to vehicle speed.
Vary the delay by turning the
adjustment ring.
If you turn it to the shortest delay (
position), the wipers change to low
speed operation when the vehicle
speed exceeds 12 mph (20 km/h).
LO － The wipers run at low speed.
HI － The wipers run at high speed.
Windshield Washers － Pull the
wiper control lever toward you, and
hold it. The washers spray until you
release the lever. The wipers run at
low speed, then complete one more
sweep after you release the lever.
On Canadian models
When you activate the windshield
washer with the headlights turned
on, the headlight washer will be
activated under certain conditions.
For more information, see
Headlight
Washers
section in the next column.
ADJUSTMENT RING
CONTINUED
Windshield Wipers and Washers
137
Instruments and Controls
To Next Page
Loading...
