3. Press and release the SET button
on the door. You will hear a beep.
Immediately press and hold one of
the memory buttons (1 or 2) until
you hear two beeps. The indicator
in the memory button will come
on. The current positions of the
driver's seat, steering wheel, and
outside mirrors are now stored.
Doing any of the following after
pressing the SET button will cancel
the storing procedure.
●
Not pressing a memory button
within 5 seconds.
●
Readjusting the seat or steering
wheel position.
●
Readjusting the outside mirror
position.
On models without keyless access
system
●
Turn the ignition switch out of the
ON (II) position.
On models with keyless access
system
●
Change the power mode from ON.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button's memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
SET BUTTON
MEMORY BUTTONS
CONTINUED
Driving Position Memory System
181
Instruments and Controls
To Next Page
Loading...
