K E Y L E S S M E M O R Y S E T T I N G S
2. Check the MID:
• If you have the correct remote, the driver ID that first appears on
the MID will match the ID number on the back of your remote.
Go to step 3.
• If the numbers do not match, follow these simple instructions:
- Remove the key from the ignition switch.
- Press the unlock button on your remote.
- Insert the key into the ignition switch, turn it to ON (II), and
checkthe MID. The driver ID that first appears on the MID
should now match the number on the back of your remote.
When linked, each remote (labeled 1 or 2 on the back) activates its own set of driving
position memory and customized settings (through the MID).
1. Verify that you are using the correct remote by inserting the key in
the ignition switch and turning to ON (II).
C h e c k p o i n t
3. Once you have the correct remote, you can begin to program your
Keyless Memory Settings.
C u s t o m i z i n g S e t t i n g s
D r i v i n g P o s i t i o n M e m o r y S y s t e m ( D P M S )
1. Turn the ignition switch to
ON (II). Shift into Park (P).
3. Press the SET button. You will
hear a beep.
2. Adjust your preferred seat
settings.
4. Press the memory button
corresponding to the remote
(1 or 2) you are using. You will
hear two beeps.
* See Customized Settings in your Owner’s Manual for other programmable settings.
Note: A stored memory position is linked to the corresponding keyless remote
(1 or 2). The driver’s seat begins to adjust when you unlock the driver’s door
with the remote and enter the vehicle.
98
To Next Page
Loading...
Need help?
General
