5. Rotate i to select a method for
specifying the area. Press u.
The following options are available:
• Address: Specify the general area by entering an address.
2 Address P. 70
• Map Input: Specify the general area by map input.
2 Map Input P. 87
6. If you select Map Input, scroll the
map to position the cursor over
your desired start point, adjusting
the map scale as necessary. Press
u to mark the start point.
To redo the area selection, press
the CANCEL button.
7. Scroll the map to “draw” the area.
Press u to mark the end point.
8. Press u to select OK.
The area you specify is displayed
in the list of areas to avoid.
To Next Page
Loading...
