Adjust Alarm Volume
Select the warning alarm volume
from three levels.
You can choose this customize item
from ‘‘METER SETUP’’ by pressing
the INFO (▲/ ▼) button repeatedly.
Press the SEL/RESET button to see
the selections.
Select the desired level by pressing
the INFO (▲/▼) button, then enter
your selection by pressing the SEL/
RESET button.
When your selection is successfully
completed, the display changes as
shown above, and then goes back to
the customize item screen.
If the ‘‘SETTING INCOMPLETE’’
message appears, go back to
‘‘ADJUST ALARM VOLUME’’ and
repeat the procedure again.
CONTINUED
Multi-Information Display
93
Instruments and Controls
08/06/06 16:58:07 09 ACURA MDX MMC North America Owner's M 50 31STX620 enu
To Next Page
Loading...
Need help?
General
