K E Y L E S S M E M O R Y S E T T I N G S
98
2. Check the MID:
• If you have the correct remote, the driver ID that first appears on
the MID will match the ID number on the back of your remote.
Go to step 3.
• If the numbers do not match, follow these simple instructions:
- Remove the key from the ignition switch.
- Press the unlock button on your remote.
- Insertthe key into the ignition switch, turn it to ON (II), and
checkthe MID. The driver ID that first appears on the MID
should now match the number on the back of your remote.
C u s t o m i z i n g S e t t i n g s U s i n g t h e M I D
1. Select “CHG SETTING.”
3. Select “AUTO DOOR
UNLOCK.”
4. Select “SHIFT TO P.”
5. Select “ALL DOORS.”
6. Once the setting has been
saved, select “EXIT.”
Six groups of settings can be programmed using the MID*: Adaptive Cruise Control
(ACC) Setup (if equipped), Meter Setup, Position Setup, Lighting Setup,
Door/Window Setup, and Wiper Setup.
SEL/RESET
button
Info
button
Press the Info button to toggle to
the “Keyless Memory Settings”
display, then press SEL/RESET to
activate the menu.
M o d i f y i n g t h e A u t o D o o r U n l o c k S e t t i n g
* See Customized Settings in your owner’s manual for other programmable settings.
When linked, each remote (labeled 1 or 2 on the back) activates its own set of
programmable audio, climate, driving position memory, and customized settings (MID).
1. Verify that you are using the correct remote by inserting the key in
the ignition switch and turning to ON (II).
C h e c k p o i n t
2. Select “DOOR/WINDOW
SETUP.”
3. Once you have the correct remote, you can begin to program your
Keyless Memory Settings.
As the default setting, only the driver's door unlocks when you shift to Park.
Follow the steps below to set all doors to unlock when you shift to Park:
11 MDX ATG:ATG_NEW STYLE 7/21/2010 5:48 PM Page 6
To Next Page
Loading...
Need help?
General
