98
C u s t o m i z i n g S e t t i n g s U s i n g t h e M I D
1. Select “CHG SETTING.”
3. Select “AUTO DOOR
UNLOCK.”
4. Select “SHIFT TO P.”
5. Select “ALL DOORS.”
6. Once the setting has been
saved, select “EXIT.”
Six groups of settings can be programmed using the MID*: Adaptive Cruise Control
(ACC) Setup (if equipped), Meter Setup, Position Setup, Lighting Setup,
Door/Window Setup, and Wiper Setup.
SEL/RESET
button
Info
button
Press the Info button to toggle to
the “Keyless Memory Settings”
display, then press SEL/RESET to
activate the menu.
M o d i f y i n g t h e A u t o D o o r U n l o c k S e t t i n g
* See Customized Settings in your Owner’s Manual for other programmable settings.
2. Select “DOOR/WINDOW
SETUP.”
As the default setting, only the driver's door unlocks when you shift to Park.
Follow the steps below to set all doors to unlock when you shift to Park:
D R I V I N G P O S I T I O N M E M O R Y S Y S T E M ( D P M S )
Store driver’s seat, steering wheel, and side mirror positions into memory for each
corresponding keyless remote (1 or 2), which are recalled when you unlock the
driver’s door with the remote and enter the vehicle.
H o w I t W o r k s
1. Turn the ignition switch to
ON (II). Shift into Park (P).
3. Press MEMO. You will hear a
beep.
2. Adjust your preferred seat,
steering wheel, and outside
mirror settings.
4. Press the memory button
corresponding to the remote
(1 or 2) you are using. You will
hear two beeps.
Note: Stored positions can also be recalled by pressing memory buttons (1 or
2) on the door.
To Next Page
Loading...
Need help?
General
