Message Condition Explanation
●
Appears when you try to change the gear position
without depressing the brake pedal.
●
Depress the brake pedal, then select a shift button.
●
Appears when you try to change the gear position
without releasing your foot off the accelerator pedal.
●
Release your foot off the accelerator pedal, then select a
shift button.
●
Appears when the (P button is pressed while the
vehicle is moving.
●
Appears if you change the gear position to (R while the
vehicle is moving forward, or to (D while the vehicle is
reversing.
●
Make sure that the vehicle comes to a stop before
operating the select button.
●
Appears when you set the power mode to ON without
fastening the driver’s seat belt.
●
Appears when you change the gear position after (P
has been automatically selected with the driver’s door
open, the driver’s seat belt unfastened, then the brake
pedal is released.
●
Fasten the seat belt properly before you start to drive.
2 Shift Operation P. 349
●
Appears when you press the (P button but it is not
engaged due to low ATF temperature.
●
Depress the brake pedal until this message disappear.
16 ACURA MDX-31TZ56200.book 98 ページ ２０１５年３月４日 水曜日 午後２時５９分
To Next Page
Loading...
Need help?
General
