The security system automatically
sets 15 seconds after you lock the
doors, hood, rear window, roof panel
and trunk. For the system to activate,
you must lock the doors from the
outside with the key, lock tab, door
lock switch, or remote transmitter.
The security system indicator next
to the driver’s door lock starts
blinking immediately to show you
the system is setting itself.
Once the security system is set,
opening either door (without the key
or the remote transmitter), the hood,
the roof panel, or the rear window
will cause the system to alarm. It
also alarms if the radio is removed
from the dashboard or if the wiring
is cut.
The security system helps to protect
your vehicle and valuables from theft.
The horn sounds and all the exterior
lights flash if someone attempts to
break into your vehicle or remove
the radio. This alarm continues for 2
minutes unless you turn it off
manually. To turn the system off,
unlock either door with the key or
the remote transmitter.
With the system set, you can still
open the trunk with the master key
without triggering the alarm. The
alarm will sound if the trunk lock is
forced or smashed, or the trunk is
opened with the release button on
the driver’s door, or the emergency
trunk opener.
The security system does not set if
the hood, rear window, trunk, roof
panel or either door is not latched
completely. If the system will not set,
check the Door and Lamp Monitor
on the instrument panel (see page
), to see if the doors, rear window,
roof panel and trunk are fully closed.
Since it is not part of the monitor,
manually check the hood.
Do not attempt to alter this system
or add other devices to it.
45
Security System
Features
99
SECURITY SYSTEM INDICATOR
０４／０８／１２ １６：２７：１９ ３１ＳＷ０６４０ ０１０２
To Next Page
Loading...
Need help?
General
