Driving and Operating 167
Starting and Operating
New Vehicle Break-In
Power Button
The vehicle has an electronic pushbutton start.
The Remote Key must be in the vehicle for the
system to operate. If the vehicle will not start,
place the Remote Key in the transmitter pocket,
inside the center console.
ON/RUN : This position is for starting and
driving. With the vehicle off, and the brake
pedal applied, pressing POWERO once will
place the vehicle in ON/RUN. When the vehicle
ready light is on in the instrument cluster, the
vehicle is ready to be driven. This could take up
to 15 seconds at extremely cold temperatures.
Service Mode
This power mode is available for service and
diagnostics, and to verify the proper operation
of the service vehicle soon light as may be
required for inspection or maintenance
purposes. With the vehicle off, and the brake
pedal not applied, pressing and holding
POWERO for more than five seconds will place
the vehicle in Service Mode. The instruments
and audio systems will operate as they do in
ON/RUN, but the vehicle will not be able to be
driven. The propulsion system will not start in
Service Mode. Press POWERO again to turn the
vehicle off.
STOPPING THE VEHICLE/OFF : To turn the
vehicle off, apply the brakes, press the button
on top of the shift lever to shift to P(Park) and
press POWERO.
Alternatively, apply the brakes and press
POWERO. The electric drive unit will shift to
P(Park) then shut off automatically.
Retained Accessory Power(RAP) will remain
active until the driver door is opened.
If the vehicle must be shut off in an emergency:
1. Brake using a firm and steady pressure. Do
not pump the brakes repeatedly. This may
deplete power assist, requiring increased
brake pedal force.
2. Shift the vehicle to N(Neutral). This can be
done while the vehicle is moving. After
shifting to N(Neutral), firmly apply the
brakes and steer the vehicle to a safe
location.
Notice
Avoid making hard stops for the first 322km
(200mi). During this time the new brake
linings are not yet broken in. Hard stops with
new linings can mean premature wear and
earlier replacement. Follow this breaking-in
guideline every time you get new brake
linings. Following break-in, vehicle speed and
load can be gradually increased.
Notice
Placing the vehicle in Service Mode will use
the 12-volt battery. Do not use Service Mode
for an extended period, or the vehicle may
not start.
3BA_KAKC_3136T6000.book 167 ページ ２０２３年１２月２０日 水曜日 午後２時１０分
To Next Page
Loading...
