To Next PageTo Next PageWhat to do if my AcuRite 02074 display screen is not working?
First, check that the batteries are installed correctly and replace them if needed. If that doesn't work, reset the display by pressing the reset button on the back of the unit. Note that you will need to enter the date and time after a reset.
How to fix no outdoor sensor reception on AcuRite Wireless weather station?
To fix the lack of outdoor sensor reception, try the following: * Relocate the display unit or the outdoor sensor, ensuring they are within 330 ft (100 m) of each other. * Position both units at least 3 feet (0.9 m) away from electronics that could cause interference, such as TVs, microwaves, and computers. * Use standard alkaline batteries (or lithium batteries in the sensor when the temperature is below -4ºF/-20ºC). Avoid using heavy-duty or rechargeable batteries. Note that it can take up to 20 minutes for the display unit and sensor to synchronize after replacing the batteries.
What to do if outdoor temperature is flashing or showing dashes on my AcuRite 02074?
If the outdoor temperature is flashing or showing dashes, it may be due to wireless interference. Bring both the sensor and display unit indoors and remove at least one battery from each. Reinstall the battery in the outdoor sensor, then reinstall the battery in the display unit. Let the units sit within a couple of feet of each other for about 20 minutes to establish a strong connection.
How to correct inaccurate temperature or humidity readings on my AcuRite 02074 Wireless weather station?
To correct inaccurate temperature or humidity readings, ensure that both the display unit and sensor are placed out of direct sunlight and away from any heat sources or vents. Also, make sure both units are positioned away from moisture sources.
Why is my AcuRite 02074 forecast inaccurate?
The weather forecast icon predicts conditions for the next 12 to 24 hours, not current conditions. Also, the Learning Mode icon must disappear from the display unit for accurate forecasting; allow the unit to run continuously for 33 days to complete Learning Mode. Removing batteries or resetting the display restarts Learning Mode. The forecast should be fairly accurate after 14 days, but Learning Mode calibrates for 33 days.
General| Display Type | LCD |
|---|---|
| Indoor Temperature Range | 32°F to 122°F (0°C to 50°C) |
| Outdoor Temperature Range | -40°F to 158°F (-40°C to 70°C) |
| Humidity Range | 1% to 99% |
| Wireless Range | 330 feet (100 meters) |
| Power Source (Display) | AC adapter or batteries |
| Power Source (Sensor) | Batteries |
| Data Reporting/Update Interval | Every 60 seconds |
