Adam Hall SLT001E - User Manual

To Next Page

BEDIENUNGSANLEITUNG

USER´S MANUAL I MANUEL D´UTILISATION

SLT001E / SLT001EW COMPUTER LAPTOP STAND

PARTS

Adam Hall GmbH · Daimlerstr. 9 61267 Neu-Anspach Germany

Tel.: (+49) 60 81 / 94 19 0 Fax.: (+49) 60 81 /94 19 1000 e-mail: mail@adamhall.com

1.Take one of the upper supports and place it over one of the lower supports (see ﬁgure A). Align the upper support holes with the lower support

mounting holes to obtain the desired height. Place one knob at a time through the mounting holes (must be spaced at least 2 holes apart). Take a

stabilizer bar and screw the top knob into the end of the stabilizer bar. Repeat with bottom knob.

2.Repeat above with the other upper support and lower support for the opposite side of the stand (see ﬁgure B). Secure all knobs tight to minimize

stand wobble.

SUPPORT ASSEMBLY

Figure B

Place Upper

support over

Lower support, so

that the Upper

Support is on the

outside of the

stand

Knobs must be

spaced at least 2

holes apart

Figure A

Need help?

Do you have a question about the Adam Hall SLT001E and is the answer not in the manual?

Summary

Visual identification of all parts included in the laptop stand kit, including supports, bars, and hardware.

Instructions and figures detailing the correct procedure for assembling the computer laptop stand.

General