19
AR253 AR253-B
11l
11m
11k
With the end of the arm core facing you, slide the arm core over the hand end of
the core, all the way to the shoulder.
Be sure that the new vein system is still in the vein channels in the arm core. If the
vein is not in the channel in the core it can be pushed back into the channel through
the skin.
Replace the end cap by threading both ends of the vein through the two holes,
pushing firmly into place
11i
11j
Insert the rest of the vein system into its corresponding channels in the arm core,
keeping the two ends of remaining vein out of the way during installation of the
new arm skin.
Apply the lubricant (as supplied in the / kit) liberally down the
inside of the new skin and work it down by rubbing sides together.
2. Insert the New Vein System (Continued)
3. Installing the New Arm Skin
Please observe the warnings on the lubricant label.
11n
Replace both blue vein connectors in each end of the new vein system.
The arm is now ready for use again.
Ensure that the veins are kink free and pulled fully through the end cap.
To Next Page