7
2a
1a
1c
1b
2b
3b
2c
Unscrew the cap of the bottle with the tube and bulb attached.
Replace cap and shake well to mix.
Prepare artificial blood by putting 10 grams (Approx. 1 teaspoon) of artificial blood
powder concentrate in the bottle and fill with water to the “Max Level” line.
Connect the arm veins to both bottles using the blue connectors.
Locate the connector and insert fully into the valve.
Continue to pump the bulb until blood begins to flow through the arm and into the
other bottle.
Twist the connector clockwise until it locks into place.
Making the Blood Concentrate
Ensure the work area is clean and dry.
Keep paper towels nearby in case of any spillage.
Locate the bottles in the arm rest holder positioning the blue connectors to the
slots in the back.
Place the arm with the palm of the hand facing down, supporting the arm at the
shoulder end on the arm rest.
Setting Up the Arm Rest and Connecting the Veins to the Bottles
Pressurising the Blood System
3a
Pump the bulb to charge the vein system.
Do not over pressurise the system. The pressure release valve on the second
bottle will automatically open if the system is over pressurised.
There should be no visible air bubbles in the veins before use. If bubbles are
present, keep charging the system until there is a steady flow of blood.
To Next Page
Loading...