3
S CONTROL MANUAL [ENGLISH]
After starting up, S Control automatically identifies the specific S Series hardware you
are using. It will then display your loudspeaker’s model and serial number at the bottom
left of the S Control window. The correct User and Factory presets for your specific
S Series speaker will also be displayed [UNR, Pure, and Classic Factory presets and
two User memories for the S3H; UNR, Pure and three User presets for all other models].
The current firmware active in the connected speaker is also identified and displayed
at the bottom right. If the computer is connected to the Internet, S Control will make a
comparison to the latest firmware version available on the ADAM Audio web site. If the
speakers are running outdated firmware, the user will be offered an update, which can
be obtained and installed simply by pressing the red Firmware Update button at the
bottom right of the app.
IMPORTANT: It is essential that communication between the S Control app and your
S Series loudspeaker is not interrupted when Storing or Reading presets, or when
updating the firmware, as this may corrupt your speaker‘s presets and memories.
In short, be sure never to disconnect the USB connection while Reading or Storing is
in progress. The Read/Store processes should in any case only take a few seconds.
For the same reason, dialog box warnings will also appear if you try to quit S Control
while a Store or Read process is underway.
To Next Page
Loading...
Need help?
General