6. Pairing
Prior to using the speakerphone for the rst time, you must pair it with a Bluetooth-enabled mobile hand-
set. The following steps describes pairing instruction for a typical Bluetooth-enabled mobile handset.
(a) Place
the speakerphone and mobile handset no more than 1 meter apart.
(b) Ensure the speakerphone is under OFF mode.
(c) Press and hold the MFB for 6 seconds until you hear a long beep. The LED will ash red and blue
alternatively. It’s now ready for pairing.
(d)
Activate your mobile handset’s Bluetooth function by referring to your mobile handset user guide for
details. Mean while, the handset will search for accessible Bluetooth devices.
(e) Select “AD-686”
from the list.
(f) Enter the pre-programmed passkey “0000” and press “OK” to pair the speakerphone and the hand
-
set. When pairing is completed, you may hear a long beep and LED will ash blue 3 times. Now the
speakerphone is under standby mode with LED ashes blue every 3 seconds.
(g) Press “Return” to go back to your handset’s main menu. (For most of the mobile handset models,
a headset icon will be shown on the screen.) You should now be able to make and receive calls
through the speakerphone. Please place the mobile handset to the speakerphone no more than 10
meters. (Obstruction could cause shorter sensing distance.)
Important:
Under the pairing mode, if the pairing cannot be completed within 2 minutes, the speakerphone’s LED will
ash off and speakerphone will be under off mode. Please repeat step (c) to (g) to pair the speakerp-
hone and mobile handset again.
7. Connection/Link between Speakerphone and Mobile Handset:
After pairing is completed, speakerphone is always under standby mode. Before you place or answer a
call, if the headset ICON is not shown on phone screen, please follow the simple steps to activate the
Bluetooth connection/link through your handset or speakerphone until the headset ICON is on the screen.
(a) On Handset: Select “AD-686” from the paired list on your handset screen.
(b) On Speakerphone: Short press MFB and select “Accept” on handset screen to accept connection.
Important:
Whenever Bluetooth connection/link is removed, for example: power off on speakerphone/mobile handset
or out of 10 meter sensing distance, please activate connection/link as suggested.
8. Disconnection between Speakerphone and Mobile Handset:
You may connect your speakerphone with another Bluetooth handset. Please follow the simple steps to
disconnect the speakerphone with the pre-paired handset.
(a) Power
off the speakerphone.
(b) Select “disconnecting” to remove previous connection from your handset list.
9. Using the Speakerphone
Once pairing is completed and battery is fully charged, you may access the following functions. Some of
the below-mentioned function is only accessible for handsets supported with Hands-Free Prole.
(a) Answering a Call:
To answer a call, wait for the speakerphone to ring, then short press the MFB to accept the call or
answer the call via your mobile handset in the normal way.
(b) Ending a Call:
Short press the MFB, to end your call or end the call via your mobile handset in the normal way.
Mean while you can hear a short beep from the speaker.
(c) Reject a Call:
When you hear the ringing tone, press and hold the MFB for 3 seconds until you hear a short beep.
page 4
To Next Page
Loading...