5
USER GUIDE
ENTERING YOUR VEHICLE
Follow the next few steps:
• After opening the door, retrieve the hand held pendant.
• Push the POWER button on the top of the pendant to activate it. The light in the top corner will turn blue. This light will
flash during movements. If the pendant is not used for ten (10) seconds, the light will go off and the pendant will no
longer be active. Simply press the power button on the top of the pendant again to activate.
• Press and hold the button until the LINK has reached a desired height for your transfer.
• Once you are comfortably positioned on the LINK, press and hold the button until the LINK has completed its
cycle and is inside the vehicle. At any time throughout the movements you may release the button and the LINK will
stop, allowing you to reposition. Once you are ready to continue, simply press and hold the button to resume
your ascent into the vehicle.
• Close your vehicle door and replace the hand held pendant.
• Use the steps outlined on page 3 to adjust your seated position for appropriate legroom, space, positioning and
comfort inside your vehicle.
To Next Page
Loading...