6
USER GUIDE
EXITING YOUR VEHICLE
Follow the next few steps:
• Start by removing your seat belt and opening the door.
• Locate the hand held pendant.
• Push the POWER button on the top of the pendant to activate it. The light in the top corner will turn blue. This light
will flash during movements. If the pendant is not used for ten (10) seconds, the light will go off and the pendant
will no longer be active. Simply press the power button on the top of the pendant again to activate.
• Press and hold the button until the LINK has reached a desired height for your transfer. At any time you
may release the button and the LINK will stop moving allowing you to reposition. Once you are ready to continue,
simply press and hold the button to resume your descent out of the vehicle.
• Once you have transferred out of the seat, press and hold the
button until the LINK has returned
completely inside the vehicle.
• Replace the hand held pendant and close your vehicle door.
WARNING
NEVER TRY TO OPERATE THE
LINK WHILE THE VEHICLE DOOR IS CLOSED OR IF THE VEHICLE IS IN MOTION.
To Next Page
Loading...