Need help?Do you have a question about the ADB Safegate ERES and is the answer not in the manual?
Product compliance with essential safety and hygiene requirements.
Product compliance with safety and FAA Airfield regulations.
Warranty for LED airfield guidance signs against defects.
Warranty against mechanical, electrical, and physical defects.
Compliance of LED products with FAA, ICAO, and IEC standards.
General safety instructions, including hazard icons and qualified personnel definition.
General safety instructions for installing and using ADB SAFEGATE equipment.
Defines the specific function and limitations of the equipment's use.
Guidelines for proper storage and handling to prevent damage.
Warnings and precautions related to electrical hazards and arc flash.
Glossary of terms and abbreviations used in the manual.
Details on LED lights for runway edges, thresholds, and ends, including standards.
Information on the additional capacity for IQ function load calculations.
Guidance on dimensioning isolation transformers for 2A systems.
Explanation of markings and indicators on the fixture.
Description of the frangible coupling mechanism and its components.
Configuration details for combined threshold and end fixtures.
Details on the monitoring option for light status and fault detection.
Information about the arctic kit for cold weather performance.
Procedures for inspecting delivered equipment for damage.
Guidelines for proper storage of the fixture before installation.
Steps and precautions for installing the fixture.
Defines the specific function and limitations of the equipment's use during installation.
Steps to prepare the fixture before installation.
Detailed steps for physically mounting the fixture.
Instructions for aligning the fixture using a reference mark.
Steps to attach and orient the alignment tool on the fixture.
Procedures for leveling and aligning the fixture using spirit levels.
How to check and verify the fixture's alignment and levelness.
Final steps after alignment, including checking lens color and toe-in.
Steps and tools required to safely remove the fixture.
Essential safety precautions to be followed during maintenance.
Regular checks and actions to maintain fixture performance.
General procedures and list of parts that can be replaced.
Step-by-step guide for replacing the complete optical head.
Instructions for removing and installing the optical cover and gasket.
Procedures for replacing the optical kit components.
Steps to replace the arctic kit, including spacers and screws.
Guide for replacing the main body of the fixture.
Instructions for removing and installing the cooling block.
Steps to replace the body support assembly.
Procedures for replacing cable leads, earthing wires, and bushings.
Instructions for replacing the frangible coupling or column.
Steps to repair a light that has a monitoring option malfunction.
Guide for replacing the fuse resistor in monitoring options.
Steps to reassemble the complete optical head after replacement.
Procedure to verify the fixture's functionality after installation or repair.
Safety precautions to avoid improper operation and damage.
A table listing common problems, causes, and solutions.
A visual breakdown of the fixture's components with part numbers.
List of fixture components, their versions, and article numbers.
Specifications for screws and recommended torque values.
Information on available optional parts and accessories.
General| Brand | ADB Safegate |
|---|---|
| Model | ERES |
| Category | Lighting Equipment |
| Language | English |
To Next Page
