Quick Start Guide
advantage connect
®
Model 6024N
1.
Insert batteries,
observing polarity.
2. Insert the cuff connector
into the port on the
left side of the unit.
3. Apply cuff to bare upper arm. Artery mark should align
with brachial artery.
4. Sit comfortably in a chair with the
seat back and your feet resting on
the floor. Legs should not be crossed.
Arm should be supported yet relaxed
and positioned level with your heart.
Rest for two minutes before starting
measurement.
4 x AAA,
1.5V
i
See page 12 in the instructions for use to set date and time or press
the on/off button once to skip this step.
i
The monitor defaults to single measurement mode. See page 13 in
the instructions for use to change to three-reading average mode.
See page 14 in the instructions for use if you plan to use the
ADC@Home app and would like to get set up now.
3/4” to 1”
above elbow
Tube toward
lower arm
Artery
Mark
To Next Page
Need help?
General
