Note:
Battery polarity should be observed to prevent damage to the device. •
When battery is low, the battery indicator symbol on the display will flash. Replace low battery•
as soon as possible. Remove battery if the device will not be used for more than 30 days.
Strap Installation (figure 2)
1. Thread thinner end of the strap through the loop.
2. Thread thicker end of the strap through the threaded end
before pulling it tightly.
Operation Instructions (figure 3)
1. Hold the Advantage™ 2200 with the display screen facing toward you as shown in Figure 3.
Gently squeeze the hinged end and insert one finger into the device fully. Release hinged end to allow
device to clamp down onto finger. Be sure finger is fully inserted. (When your finger is inserted into
the device, your nail surface must be facing the same side as the display.)
2. Press the power button on the front panel once.
3. Remain still while taking a measurement and avoid applying pressure to the clamped device
while in use.
4. The device will display a reading once it has had a moment to begin measurement.
Note:
The rubber inside the Oximeter that touches the finger may be cleaned•
with alcohol.
For best results, keep the Advantage™ 2200 at heart or•
chest level.
The index (pointer) finger is recommended.•
While on the finger, do not press the Ad-•
vantage™ 2200 against any surface and
do not squeeze it or hold the device.
The internal spring provides the cor-•
rect pressure. Additional pressure
may affect readings.
(Figure 1)
1.
2.
(Figure 2)
(Figure 3)
To Next Page
Loading...
