ADCP-61-471 • Issue 4 • June 2000 • Section 2: Operation and Maintenance
2-282
© 2000, ADC Telecommunications, Inc.
TAD-105
Page 6 of 8
Table 105-1. TL1 Commands
COMMAND DESCRIPTION
General System Commands
REPT-INITZN Report Initialization
REPT-STAT Report Status
RTRV-HDR Retrieve header
SET-DAT Set system time and date
SET-SID Set system ID
DS1 Loopback Commands and Responses
OPR-LPBK Operate loopback
RLS-LPBK Release loopback
RTRV-LPBK-T1 Retrieve loopback
SET-LPBK-T1 Set T1 loopback codes
Performance Monitoring Commands and Responses
ALW-MSG Allow automatic messages
ALW-PMREPT Allow PM reporting on line(s) that have been inhibited
INH-MSG Inhibit automatic messages
INH-PMREPT Inhibit PM reporting
INIT-REG Initialize register
OPR-ACO Operate alarm cutoff
RTRV-ALM Retrieve active alarms
RTRV-ATTR Retrieve alarm attributes
RTRV-COND Report conditions (events, etc.)
RTRV-ITH Report internal threshold
RTRV-PM Retrieve PM history on a line or lines
RTRV-PMSCHED Retrieve PM schedule
RTRV-TH Retrieve threshold
SCHED-PMREPT Schedule PM, select parameters to measure
SET-ATTR Set severity and activation of alarm and event reporting
SET-ITH Set internal threshold
SET-TH Set threshold for reporting events
SW-TOPROTN Switch to protection
SW-TOWKG Switch to working
(continued)
To Next Page
Loading...