Need help?Do you have a question about the Adcom GFA-5300 and is the answer not in the manual?
Power| power rating into 8 ohms | 80 watts continuous average power per channel |
|---|---|
| power rating into 4 ohms | 125 watts continuous average power per channel |
| power consumption - quiescent | 100 VA |
| power consumption - maximum | 720 VA |
| power consumption - 80 watts into 8 ohms | 510 VA |
| power consumption - 125 watts into 4 ohms | 720 VA |
| power supply voltage | 115 VAC - 50/60 Hz |
Distortion and Noise| IM distortion SMPTE 8 ohms | ≤ 0.07% |
|---|---|
| IM distortion SMPTE 4 ohms | ≤ 0.07% |
| IM distortion CCIF 8 ohms | ≤ 0.035% |
| IM distortion CCIF 4 ohms | ≤ 0.035% |
| THD + Noise at 80 watts into 8 ohms 20Hz | 0.018% |
| THD + Noise at 80 watts into 8 ohms 1kHz | 0.02% |
| THD + Noise at 80 watts into 8 ohms 10kHz | 0.07% |
| THD + Noise at 80 watts into 8 ohms 20kHz | 0.14% |
| THD + Noise at 125 watts into 4 ohms 20Hz | 0.018% |
| THD + Noise at 125 watts into 4 ohms 1kHz | 0.02% |
| THD + Noise at 125 watts into 4 ohms 10kHz | 0.08% |
| THD + Noise at 125 watts into 4 ohms 20kHz | 0.165% |
| signal to noise ratio (A weighted) | ≥ 100 dB |
Frequency and Gain| frequency response | +0, -0.25 dB from 10Hz to 20kHz |
|---|---|
| power bandwidth | 3Hz to 130kHz |
| dynamic headroom into 4 ohms | 2.1 dB |
| gain | 29 dB |
Input and Output| input sensitivity for 1 watt | 0.1 volts |
|---|---|
| input sensitivity for 80 watts | 0.9 volts |
| input impedance | 49.9 kΩ |
| damping factor | ≥ 350 |
| rise time | 1.8 µS |
Weight and Dimensions| chassis dimensions | 4 1/2” x 17” x 11 3/8” (105mm x 432mm x 289mm) |
|---|---|
| maximum dimensions | 4 3/8” x 17” x 12 1/8” (111mm x 432mm x 308mm) |
| weight | 22 lb. (10.0 kg) |
| weight, packed | 25 lb. (11.3 kg) |
To Next Page
