February 2016
Meat Grinder Attachment:
• The Meat Grinder should only be used for purposes intended
• Please remove bones, skins and any other foreign materials before grinding
• Meats and other food should be defrosted and not used when frozen
• For best results, cut the meat into smaller size pieces to fi t easily through the feed tube
• If not in use, please remove the meat grinder attachment from the unit
• Do not run the grinder for longer periods of time then necessary
CLEANING - NOTE: To maintain cleanliness and increase service life, this item should be cleaned daily. Do not immerse the
unit in water or any other liquid, if liquid enters the electrical compartment it may cause a short circuit or electrical shock.
1. Before cleaning or attempting to move this item always turn off and unplug.
2. Wipe the entire unit with a clean soft cloth until it is completely dry.
3. To avoid damage to the unit, do not use abrasive cleaners or scouring pads.
4. If soap or chemical cleaners are used, be sure they are completely rinsed away with clean water immediately after
cleaning. Chemical residue could damage or corrode the surfaces of the unit.
5. After using of the machine, please remove the fl at beater, dough hook, wire whip and meat grinder from the machine
and wash these parts thoroughly in hot, soapy water to prevent the growth of bacteria.
To avoid serious injury or damage, never attempt to repair or replace a damaged power cord yourself. Contact a professional repair
service.
Problem Possible Causes Solution
The axles don’t work when
operating the machine
Electrical connection is not
good
Check the plug in the outlet
Leaking oil
oil gaskets are worn out or
damadged
Replace the oil gasket(s)
Diffi cult to raise or lower the
bowl
Either the slideway is
corroded, or the lead screw,
bevel gear or hand wheel
shaft is dried out
Clean and oil the dried out
parts
Motor is overheating and
speed has decreased
The voltage is not enough,
incorrect speed is set or there
is too much food in the bowl
Check the voltage or adjust
the speed to a better setting.
If the bowl is overloaded,
remove some of the food to
lighten the load
Item is making too much
noise and overheating
Poor lubrication Add or replace oil
Agitator touches bowl
Either the bowl or agitator
is deformed
Repair or replace deformed
part
Mixing bowl is out of position
Moving direction is not
correct
Adjust position
TROUBLESHOOTING
Net weight: 192 lbs (87 KGS)
Dimensions: 18” x 22.5” x 33.5” (713 X 570 X 855 mm)
To Next Page
Loading...