Safety
11
Analog wall clock CK 1601
English
BEWARE of material damage
Protect the clock from strong impacts and vibrations.
Remove the battery from the product if it is exhausted or if you will not use the
clock for an extended period of time. You will thus avoid damage that may result
from the leakage of battery acid.
Pay attention to the correct polarity (+/-) when inserting or changing the battery.
Do not expose the battery to any extreme conditions, e.g., by storing it on a heater
or in direct sunlight. Increased risk of leakage!
Clean the battery and device contacts, as needed, before inserting the battery.
Do not make any modications to the scales. Only allow repairs to be carried out
at a specialist workshop. Repairs carried out incorrectly can considerably endanger
the user.
At a glance (reverse)
1
2
You need an LR6 (AA), 1.5 V battery to use the
product.
1. Place the battery on the bottom of the
battery compartment as shown.
Pay attention to the correct polarity (+/-).
2. Hang the clock, if desired, on a nail or a screw.
For this purpose, a hanging loop is located on
the back of the clock.
3. Hang the clock, if desired, on a nail or a screw.
For this purpose, a hanging loop is located on
the back of the clock.
Maintain a secure attachment so that the
clock does not fall off and become damaged.
1
Dial
2
Battery compartment
The battery must be changed when the hands stop moving.
Only use the type of battery that is specied in the “Technical Data”.
Dispose of batteries in an environmentally appropriate way (see
“Disposal”)
Druckbuch Anlaoge Wanduhr CK 1601.indb 11 29.02.2016 12:59:07
To Next Page
Loading...
Need help?
General
Weight and Dimensions
