41
EN
− Press the WAVE button briey.
If the reception was not successful, the dot
next to the radio mast symbol
will go o
after a few minutes and the time will be
displayed normally.
Upon successful signal reception, the radio-
controlled alarm clock adjusts itself to the
time of the time signal transmitter. If you
have already set time manually, it will be
adjusted automatically .
Setting the time manually
If there is a delay of more than
approx. 20 seconds between two
pushes of a button, the setting
process is automatically terminated.
1. Press the SET button until “24 Hr” appears on
the display.
2. Select the desired time format (“12hr” or “24hr”)
by turning SET (+/–).
To Next Page
Loading...
