45
EN
Alarm
Setting the alarm time
If there is a delay of more than
approx. 20 seconds between two
pushes of a button, the setting
process is automatically terminated.
1. Slide the alarm slide switch upwards to ON.
A dot will be displayed next to
.
2. Press the SET button.
3. Select the desired alarm hour by turning
SET(+/–).
4. Press the SET button again.
5. Select the desired alarm minute by turning
SET(+/–).
Being awakened
At the set time you will be woken by an alarm
signal, which will become more intense as the
waking time increases.
To Next Page
Loading...
