2. Set the current hour-time using the MIN
button.
3. Set the current minute-time using the SEC
button.
4. Finally press START/STOP. The time has been
set.
The timer can be set to 12-hour mode
(indication of afternoon hours with
PM) or to 24-hour mode. In order to be
sure in which hour-mode the time is, let
the display indicator run through once
(press and hold MIN).
Securing the timer
NOTE on material damage
− Do not slide the timer over surfaces, this
could lead to scratching.
− Secure the timer using the magnets to the
rear side of a metallic surface.
Translation Timer 1600_01 Ordner.indb 32 25.02.2016 09:14:31
To Next Page
Loading...
