45
Weather Station with Wireless Outdoor Sensor WS 2136-x
English
Where possible, use alkaline rather than
zinc-carbon batteries. Alkaline batteries
last longer, especially at low outdoor
temperatures.
Change the batteries when a corresponding
symbol
appears on the display for IN or
OUT.
Wireless outdoor sensor
1. Remove the battery compartment cover on the rear
side of the outdoor sensor by pressing with a little force
on the imprinted arrow. Slide the battery compartment
cover in the direction of the arrow, away from the
outdoor sensor.
2. Insert 2 batteries of type LR03 (AAA)/1.5 V as depicted
on the bottom of the battery compartment. Pay
attention to the correct polarity of the batteries (+/-).
3. Slide the battery compartment cover back into place
on the outdoor sensor.
Base station
1. Push down the locking tab of the battery compartment
cover and remove the battery compartment cover.
2. Insert 2 batteries of type LR6 (AA)/1.5 V as depicted on
the bottom of the battery compartment. Pay attention
to the correct polarity (+/-).
3. Close the battery compartment again. The locking tab
must snap audibly into place.
To Next Page
Loading...
Need help?
General
