ADEMCO 5802WXT - User Manual

ADEMCO 5802WXT Supervised Miniature
Transmitter – Installation Instructions
General Information
The ADEMCO 5802WXT is a wireless transmitter that may be worn around
the neck, on a wrist band or as an apparel clip that may also may be mounted
to a desk, dresser, etc. (necklace, band, and clip supplied). Pressing and
holding the transmitter button for two seconds sends a signal to the control
receiver. The 5802WXT is intended for use only with wireless alarm systems
that support 5800 Series devices.
The transmitter is supervised, i.e., it automatically sends a message to the
control receiver that includes battery status information every 70-90 minutes.
This transmitter can be programmed as any zone type response (e.g.,
Emergency Panics, Relay Action, etc.).
Programming the Serial Number
The 5802WXT has a unique identification code (serial number) permanently
assigned during manufacture.
You must “enroll” the transmitter’s serial number and loop number during
system programming. The 5802WXT may be defined as Input Type “RF”
(supervised RF, for an hourly check-in; do not take out of range) or “UR”
(Unsupervised RF). Its loop number is “1.” See the control unit’s Installation
Instructions for further details regarding programming. When installation is
complete, verify operation from desired location(s).
Battery Replacement
The 5802WXT is powered by a long-life Lithium battery that may be replaced
when a low battery is eventually indicated by the control unit.
NOTE: When replacing the battery, wait a minimum of 30 seconds prior to installing the
new battery.
NOTE: Although water-resistant, please do not immerse in water at a depth below
10cm for more than 1 hour.
1. Remove 4 screws and lift off
cover.
2. Using a small flat-blade
screwdriver remove old battery.
3. Insert new battery by placing
new battery under the gold tab
and then pressing down.
Ensure the POS + side of
battery is face up after
installation.
4. Align cover and attach with 4
screws.

Summary

General Information

Device Overview and Features

Describes the ADEMCO 5802WXT as a supervised wireless transmitter for alarm systems, detailing its use and features like automatic check-ins.

Programming the Serial Number

Transmitter Enrollment Process

Explains the process of enrolling the transmitter's unique serial and loop number during system programming for RF or UR types.

Battery Replacement

Battery Replacement Procedure

Details the steps to replace the lithium battery, including screw removal, old battery extraction, and new battery insertion.

Specifications

Technical Specifications

Lists unit dimensions, LED function, and battery type for the transmitter.

Federal Communications Commission Statements

FCC;IC Compliance Statements

Outlines FCC and IC statements regarding device operation and interference, including conditions for use.

Support & Warranty

Online Support and Warranty Resources

Directs users to online resources for documentation, support, and warranty information.

ADEMCO 5802WXT Specifications

General

Brand	ADEMCO
Model	5802WXT
Category	Transmitter
Language	English