23. Do not operate tool if under the influence of alcohol or drugs. Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired while
taking drugs. If there is any doubt, do not operate the tool
Unpacking
When unpacking, check to make sure that all parts are included (refer to Parts List and
Diagram at end of manual). If any parts are missing or broken, please call seller.
Electrical information
Guidelines for using extension cords
WARNING! THIS WOOD LATHE IS FOR INDOOR USE ONLY. DO NOT EXPOSE TO RAIN
OR USE IN DAMP LOCATIONS.
Make sure your extension cord is in good condition. When using an extension cord, be sure to
use one heavy enough to carry the current your product will draw. An undersized cord will
cause a drop in line voltage resulting in loss of power and overheating. The table below shows
the correct size to use according to cord length and nameplate ampere rating. If in doubt, use
the next heavier gauge.
Extension lead sizes shown assure a voltage drop of not more than 5% at rated load of
tool.
Ampere rating
(on name plate)
WARNING! THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE
OPERATOR FROM ELECTRICAL SHOCK.
Mounting Lathe to Workbench
1. Measure the thickness of your workbench.
2. Obtain four bolts that are the lengths for the workbench, and 1 inch for the wood lathe.
Make sure that nuts and flat washers are also obtained.
3. Mark and drill holes through the workbench, using the Lathe Bed (58) as a template,
for the four mounting holes on the Wood Lathe.
4. Position the Wood Lathe on your workbench and line up the holes you drilled in Step 3
with the Mounting holes in the Lathe Bed (58).
To Next Page
Loading...