Adesso Collette - User Manual

4218-01/22 1.0
Assembly Instructions (English)
21 Penn Plaza Suite 909 New York,NY 10001
Tel: (212) 736 4440 Fax: (212) 736 4806
www.adessohome.com
ASSEMBLY INSTRUCTION FOR
Collette LED Floor Lamp
Model# 4218-01/ 22
1. Screw tube (B), (C), (D) and (E) together until tight.
2. Place threaded tube of tube (B) through hole on base (A) while gently pulling any
excess cord through base.
Note: The lamp should face forward, with cord coming out of the back of the base.
3. Slowly tilt the lamp on its side to get access to bottom of base in order to tighten it
with washer (G) and nut (H) securely using wrench (I).
4. Screw the handle bar (F) onto the lamp.
5. Connect the adaptor (K) with cord (J).
GENERAL PRODUCT INFORMATION:
This product is suitable
for dry locations only.
---------------------------------------------------------------
IMPORTANT SAFETY INSTRUCTIONS:
This portable lamp has a polarized plug as a feature to reduce the risk of electric shock (one blade is
larger than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully
in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician.Do not use with an
extension cord unless the plug can be fully inserted. DO NOT ALTER THE PLUG .
PARTS DIAGRAM
(1) *handle bar (F) (1) * adaptor (K)

Summary

Collette LED Floor Lamp Assembly Steps

Step 1: Connect Lamp Tubes

Screw lamp tubes (B), (C), (D), and (E) together until tight.

Step 2: Attach Base and Thread Cord

Place threaded tube (B) through base (A), pulling excess cord through.

Step 3: Secure Base Attachment

Tilt lamp, attach washer (G) and nut (H) to base using wrench (I).

Step 4: Attach Handle Bar

Screw the handle bar (F) onto the lamp assembly.

Step 5: Connect Power Adaptor

Connect the power adaptor (K) to the cord (J).

General Product Information

Important Safety Instructions

Parts Diagram

Adesso Collette Specifications

General

Brand	Adesso
Model	Collette
Category	Work Light
Language	English