EasyManua.ls Logo

Adexa ADM10 - User Manual

Default Icon
56 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Teigknetmaschine
V1.2
(D) Bedienungsanleitung

Table of Contents

Questions and Answers

  • C
    Christopher GarciaAug 10, 2025
    What to do if my Adexa ADM10 is not working?
    • U
      uschroederAug 10, 2025
      If your Adexa Commercial Food Equipment isn't working, there are several things to check: * **Power Supply:** Ensure the house fuse is intact and the power supply and plug are functioning correctly. * **Bowl Position:** Turn the handwheel to ensure the bowl is properly raised. * **Protective Grille:** Make sure the protective grille is completely closed. * **Gear Engagement:** Switch off the machine and operate the gear lever to ensure the gear is correctly engaged.
  • T
    Teresa KingAug 14, 2025
    What to do if my Adexa ADM10 Commercial Food Equipment stops working?
    • A
      Alexander CrosbyAug 14, 2025
      If your Adexa Commercial Food Equipment stops working, consider the following: * **Blown Fuse:** Check the house security fuse. * **Overheating:** Allow the device to cool down before restarting. * **Gear Issue:** Disconnect the equipment from the mains plug and manually turn the drive shaft. Then, select a different gear. * **Protective Grille:** Ensure the protective grille is closed. * **Bowl Position:** Adjust the handwheel until the bowl is correctly positioned.
  • W
    William MorganAug 20, 2025
    Why is my Adexa Commercial Food Equipment noisy in the machine head and overheated?
    • J
      juliegonzalezAug 20, 2025
      If your Adexa Commercial Food Equipment is making noise in the machine head and overheating, it is likely due to bad lubrication. To resolve this, fill the gearbox with lubricant.
  • C
    Chelsea MckenzieAug 25, 2025
    How to fix Adexa ADM10 lifting device that is difficult to operate?
    • G
      george84Aug 26, 2025
      If the lifting device on your Adexa Commercial Food Equipment is difficult to operate or stuck, the lift guide might be rusted or contaminated. Clean the guide and grease it to resolve this issue.
  • J
    joshua18Aug 29, 2025
    Why does oil run out of my Adexa ADM10?
    • P
      Paul MartinAug 29, 2025
      If oil is running out of your Adexa Commercial Food Equipment, it is likely due to a defective transmission seal. You will need to replace the seal.
  • E
    edwardsmichaelSep 3, 2025
    What to do if my Adexa Commercial Food Equipment only has high speed?
    • G
      gallagherangelaSep 3, 2025
      If your Adexa Commercial Food Equipment only operates at high speed, and middle and low speeds are unavailable, it could be due to: * A defective transmission block for gear adjustment: Change the transmission block. * Broken spring plate of the clutch or teeth on the gear ring: Change the spring plate or the toothed ring.

Adexa ADM10 Specifications

General IconGeneral
BrandAdexa
ModelADM10
CategoryCommercial Food Equipment
LanguageEnglish