Need help?Do you have a question about the Adey MagnaCleanse and is the answer not in the manual?
General| Brand | Adey |
|---|---|
| Model | MagnaCleanse |
| Category | Water Filtration Systems |
| Language | English |
Critical cautions for operating MagnaCleanse RapidFlush filters, including magnet proximity and system heat.
Details the MagnaCleanse flushing process, its contents, and additional items required for effective system cleaning.
Locate the three-port valve, prepare pipework, and identify the MagnaClean filter installation location.
Attach MagnaCleanse hoses between the RapidFlush filter and the HTV connector, ensuring correct drain valve placement.
Turn off isolation valves on the RapidFlush filter and carefully remove the lid assembly from its canisters.
Introduce suitable cleaner into the system via the RapidFlush filter and subsequently refill and pressurise the heating system.
Activate the heating system, ensure radiators are fully open, and agitate the furthest radiator using the VibraClean tool.
Maintain VibraClean agitation until the return hose is clear, then clean the RapidFlush filter and repeat radiator cleaning.
Isolate the boiler, connect a drain hose, and temporarily cap the expansion pipe in preparation for the cold flush.
Turn off HTV isolation valve 2, open the heating circuit, and flush pipework and radiators with cold mains water.
Turn on HTV isolation valve 2, turn off HTV isolation valve 1, and flush the boiler and RapidFlush filter with cold water.
Refill the header tank, add inhibitor, and vent any air from the filter after completing the flushing stages.
Turn on the system, reset controls, open bypass valves, and prepare for the final commissioning process.
Commission the system according to manufacturer guidelines and service the MagnaClean filter, verifying for leaks.
To Next Page
