13
5- Fan (for optional inbuilt fan available).
• Must be installed in accordance with AS/NZS 3000.
• Must be installed to the manufacturer’s specifications.
• Power supply must be installed by a licensed electrician.
• If the power cable is damaged, for any reason, do not use. Have the cord replaced
immediately.
The freestanding unit can have a fan fitted, but the base will need a custom designed fan cut out in the
bench, with air supply to each fan below the heater base. A cable will need to run from the heater to a
wall mount controller – the 240V power supply is supplied to the wall mount controller – see the fan
instruction manual for details.
NOTE: REMOVE THE FEET UNLESS REQUIRED WITH
FAN ON EXISTING HEARTH
Warnings
Danger of Electrocution: All electrical work must be carried out by a qualified electrician.
Note: All electrical components should be installed in an airy location away from hot parts
To Next Page
Loading...