ADIATEK baby - User Manual

Questions and Answers

A
Andrew ConradJul 27, 2025
Why is the squeegee on my ADIATEK baby Ultrasonic Jewelry Cleaner not drying perfectly?
- C
  Cassandra JacksonJul 27, 2025
  Several factors can cause this. Ensure the squeegee rubbers are clean and that the suction hose is correctly connected to both the recovery tank and the squeegee bar. Also, check the suction filter and make sure the suction motor switch is activated. Replace or rotate the rubbers if they are worn. If the floor is still wet in the center after drying, adjust the screw to increase pressure on the rear part of the squeegee. Finally, verify the level in the recovery tank and empty it if necessary.
E
esparzajuliaJul 31, 2025
What to do if my ADIATEK baby machine does not clean properly?
- J
  Jenna KiddJul 31, 2025
  If your machine isn't cleaning well, the brush might not be suitable; use only original brushes. You can contact the authorized technical assistance for advice. Also, the detergent solution may be insufficient, so open the solution flow adjuster. Check that the liquid detergent is in the recommended percentage.
A
Alicia YoungAug 4, 2025
What to do if the suction motor does not work on my ADIATEK Ultrasonic Jewelry Cleaner?
- J
  Jason LoganAug 4, 2025
  First, check the battery charge level displayed when you switch on the device. Next, ensure the suction motor switch is activated by verifying that its signal lamp is illuminated. Finally, check the level in the recovery tank and empty it if needed.
F
Frances DaltonAug 8, 2025
Why is there excessive foam production in my ADIATEK baby?
- B
  bradleymayerAug 8, 2025
  Excessive foam can occur for several reasons. Ensure you are using a low-foam detergent and avoid using excessive amounts of detergent, as this can damage the vacuum motor and cause solution pipe blockages. You can also add small amounts of anti-foam liquid into the recovery tank. If the floor isn't very dirty, dilute the detergent solution.
N
nancyjonesAug 13, 2025
What to do if the brush motor does not work on my ADIATEK Ultrasonic Jewelry Cleaner?
- R
  Robert EdwardsAug 13, 2025
  Check the battery charge level displayed when switching on the cleaner. Verify that the brush motor switch is activated and its signal lamp is on. Ensure the scrub control levers are activated. Also, check that the brush lift safety device and the brush wear control device are not activated.
J
Jessica SantosAug 17, 2025
Why is there insufficient water on the brush of my ADIATEK Ultrasonic Jewelry Cleaner?
- C
  Christina TownsendAug 17, 2025
  Ensure that the solenoid valve switch is activated and its signal lamp is on. Check the liquid level in the solution tank. Verify that the solution flow adjuster, located underneath the solution tank, is sufficiently open. Finally, press the brush control levers.
A
Amy ShepherdAug 21, 2025
What does it mean if LEDs (2), (3) and (4) become red on my ADIATEK baby Ultrasonic Jewelry Cleaner?
- J
  James RodriguezAug 21, 2025
  If the machine is on and one of the LEDs (2), (3), or (4) changes from green to red, it indicates an amperemetric protection is active. To reset, switch off the main switch (1), wait a few minutes, and then switch it on again.