3. Lift the recovery tank by rotating it and fix it with the suitable bar
(4).
4. Place the batteries in its compartment.
Connect the terminals, respecting the polarities, avoiding contact
with other parts that could create short circuit.
6. Reassemble all parts.
The machine and its battery check card foresee the use of traditional
lead batteries.
CHECK SETTING OF THE CHECK CARD ON THE DISPLAY (1).
In case of GEL batteries installation, it is necessary to set the battery
check card. Please contact the authorized technical assistance.
Strictly follow manufacturer/distributor indications for the
maintenance and recharge of the batteries. All
installation and
maintenance operations must be executed by specialized staff, using
suitable protection accessories.
BATTERY RECHARGER
Be sure that the battery recharger is suitable for the installed
batteries both for their capacities and type (lead/acid or GEL and
equivalent).
In the plastic bag containing the use and maintenance you will find the
coupling connector for the recharger. It must be assembled onto the
cables of your recharger, following the instructions given by the
manufacturer.
INCORPORATED BATTERY RECHARGER (OPTIONAL)
If the machine is equipped with the on-
board battery recharger (see
under "OPTIONAL ACCESSORIES”) please refer to the instructions of the
constructor of this accessory what the recharging operations concern.
The battery recharger is connected directly to the battery poles.
During the recharging operations a device is activated which does not
permit the machine's functioning.
The main cable of the battery recharger has a maximum length of two
meters (6.5 ft.) and must be connected to a single-phase socket type
CEE 7/7.
BATTERIES RECHARGING
Bring the machine on a levelled surface.
1.
Plug in batteries connector (1) placed in the rear part of the
machine, to the connector (3) of the battery recharger.
2. Proceed to the recharging keeping the tank lifted (see under
paragraph “BATTERY INSTALLATION AND SETTING OF THE BATTERY
TYPE” in “BEFORE USE”).
3.
Maintain the connection with the battery recharger until the
indication of the end of charge is not visualized.
To Next Page