3
INTRODUCTORY COMMENT
Thank you for having chosen our machine. This floor cleaning machine is used for the industrial and civil cleaning and is able to clean any type of
floor. During its advance movement, the combined action of the brush and the detergent solution removes the dirt which is aspirated through the
rear suction assembly, giving a perfectly dry surface.
The machine must be used only for such purpose. It gives the best performance if it is used correctly and maintained in perfect efficiency. We
therefore ask you to read this instruction booklet carefully whenever difficulties arise in the course of the machine’s use. In case of need, we ask you
to contact our service department for all advice and servicing as may prove necessary.
SUMMARY
INTRODUCTORY COMMENT 3
TECHNICAL DESCRIPTION 4
GENERAL RULES OF SAFETY 6
Transfer 6
Storage and disposal 6
Correct use 6
Maintenance 6
GENERAL RULES OF THE BATTERIES 6
SYMBOLOGY ON THE MACHINE 7
SYMBOLOGY ON THE MANUAL 7
INSTRUMENT BOARD AND CONTROLS LEGEND 8
LEGEND MACHINE 8
OPTIONAL ACCESSORIES 9
BEFORE USE 10
Handling of the packed machine 10
Unpacking of the machine 10
Battery installation and setting of the battery type 10
Battery charger 10
Batteries charging 11
On-board battery recharger (optional) 11
Batteries charging with on-board battery charger (optional) 11
Batteries charge level indicator 11
Hour meter (if equipped with a display) 11
Squeegee assembling 11
Adjusting the squeegee height 12
Adjusting the squeegee inclination 12
Splash guard assembling 12
Brush/es assembly and disassembly 12
Automatic brush release 13
Recovery tank 13
Detergent solution tank 13
FLOOR CLEANING 14
Starting of the machine 14
3S System “Solution Saving System” (optional) 14
Overflow device 14
Emptying detergent solution 14
Forward movement (if equipped with traction) 14
Stop (if equipped with traction) 15
Adjustment of the brush/es pressure present on some models 15
Brush/es motor overload protection device (optional) 15
Signal detergent solution reserve (H2O on the display) 15
STOP OF THE MACHINE AFTER CLEANING OPERATION 15
Emptying device detergent solution (optional) 15
DAILY MAINTENANCE 17
Recovery tank cleaning 17
Suction filter cleaning 17
Brush/es cleaning 17
Squeegee cleaning 17
WEEKLY MAINTENANCE 17
Rear squeegee rubber replacement 17
Squeegee hose cleaning 17
Cleaning of solution tank and filter 18
TWO-MONTHLY MAINTENANCE 18
Front squeegee rubber replacement 18
SIX-MONTHLY MAINTENANCE 18
Splash guard replacement 18
TROUBLESHOOTING GUIDE 19
Signals on the display (if present) 19
The suction motor does not work 19
The brush motor does not work 19
Insufficient water on the brush 20
The machine does not clean properly 20
The squeegee does not dry perfectly 20
Excessive foam production 20
PROGRAMMED MAINTENANCE 21
Periodic ordinary maintenance chart 21
To Next Page
Loading...
