Press . Use the arrow keys to navigate and select “Const”. Press .
Press or to move the cursor and select corresponding number.
Press or to increase/decrease the exact value.
Press to save the setting, or press to exit without saving.
Note: All measuring results will be added or subtracted from the constant; tolerance will be calculated into
the result.
Beep
Press . Use the arrow keys to navigate and select “Beep”. Press .
Press or to select “Yes” or “No” to switch the beep function on or off.
Press to save the setting, or press to exit without saving.
G-Sensor
Press . Use the arrow keys to navigate and select “G-sensor”. Press .
The built-in tilt sensor can be automatically calibrated. Calibration requires two measurements on a level
surface.
1. Put the instrument on a flat surface, then press button.
2. Rotate 180°, then press . The sensor will then be calibrated.
Date Settings
Press . Use the arrow keys to navigate and select “Date Setting”. Press .
Press or to select the corresponding place.
Press or to increase/decrease the exact value.
Press to save the setting, or press to exit without saving.
Brightness
Press . Use the arrow keys to navigate and select “Brightness”. Press .
Press or to adjust the brightness.
Press to save the setting, or press to exit without saving.
Reset
Press . Use the arrow keys to navigate and select “Reset”. Press .
Press or to select “Yes” or “No” to confirm whether you’d like to reset the instrument.
Press to reset, or press to exit without saving. After resetting, all personal settings will be
deleted and will revert back to the default settings.
About Us
Press . Use the arrow keys to navigate and select “About us”. Press .
There is some relevant information about software, such as software version number, ownership, and so
on. Go back to the menu system by clicking .
Troubleshooting
To Next Page
Loading...