ORDER CODE ITEM
EPC600 6-PACK SKB CASE
EFC800 8-PACK CHARGING CASE
28
Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be car-
ried out periodically to optimize light output.
• Use normal glass cleaner and a soft cloth to wipe down the outside casing.
• Clean the external optics with glass cleaner and a soft cloth every 20 days.
• Always be sure to dry all parts completely before plugging the unit back in.
Cleaning frequency depends on the environment in which the xture operates (i.e. smoke, fog resi-
due, dust, dew).
With this feature you can connect the xtures to one another using the power cable input and output
sockets.
NOTE: USE CAUTION WHEN POWER LINKING OTHER FIXTURES AS THE POWER CONSUMPTION
OF OTHER MODEL FIXTURES MAY EXCEED THE MAX POWER OUTPUT ON THIS FIXTURE! CHECK
SILK SCREEN FOR MAX AMPS.
Disconnect the unit from its power source. Remove the power cord from the unit. Once the cord has
been removed, you will nd that the fuse holder is located inside the power socket. Insert a at-head
screw driver into the power socket and gently pry out the fuse holder. Remove the bad fuse and
replace with a new one. The fuse holder also has a holder for a spare fuse.
Listed below are a few common problems the user may encounter, with solutions.
Unit not responding to DMX:
Check that the DMX cables are connected and wired correctly (pin 3 is “hot”; on some other DMX
devices pin 2 may be “hot’). Check that all cables are connected to the right connectors, as the way
in which the inputs and outputs are connected does aect the operation of the unit.
Unit does not respond to sound:
• Quiet or high pitched sounds will not activate the unit.
• Make sure that Sound Active mode is activated.
MULTIPLE UNIT POWER LINKING
FUSE REPLACEMENT
TROUBLESHOOTING
CLEANING
OPTIONAL ACCESSORIES
To Next Page
Loading...
